Christmas tree toys origami from paper Youyou can create with your own hands, if you want! Do you like three-dimensional decorations? Do you like to create? Then this master class is for you. I propose to make you a three-dimensional Christmas decoration for the house. For work we need: paper (usual for the printer), scissors, a round object for the template, a pencil, a ruler, a thread, a needle, glue and a wide paper band. Step-by-step instructions: 1. Cut ten circles of paper using, for example, a CD for the template. 2. On each circle, draw with a pencil eight lines of equal length, directed toward the center. Lines should start at the edge of the circle and end, not reaching one centimeter to the middle. We cut along the lines as shown in the photo 3. Using an acutely sharpened pencil or pen, twist each tip with a cone and glue. If you get it all the first time, congratulations. After all, this is a rather laborious work. 4. Cut two small squares from the gum. She will help keep the pieces of jewelry together. 5. We thread the thread in the needle and connect the ends of the thread together to the knot. We thread through one square of rubber bands. 6. We pass the needle through the centers of five stars, located flat side down. Thread the bottom up. The other five stars are turned upside down and pass through them, and then through the second piece of elastic band, too. Using threads and two pieces of gum, we collect ten stars together. 7. With a pencil we press on an elastic band to squeeze the stars into a ball, at the same time, pulling the thread with the other hand on ourselves. The elastic band must be so firmly attached to the ball so that you do not need to tie the knot. Straighten the ball to make it the right shape. 8. We make a loop of thread, so that you can hang a snowflake on the tree.