How to bind a double hollow gum with knitting needles to make unique and beautiful things, using free schemes, description and photos.

December 20, 2017 handmadebase

Learning to knit the “double hollow” patternrubber band" This type of elastic band is difficult to classify as any type of pattern. Here it is more appropriate to use the term knitting technique, the knowledge of which will be useful to almost every craftswoman who is interested in knitting. Double elastic can be knitted instead of regular elastic: along the bottom, cuffs or neckline. It can also act as a drawstring for a belt or for a regular elastic panty. In addition, headbands, straps, bag handles and more are knitted with double elastic.The technique of knitting a double elastic band is quite simple: we knit 1 loop, remove the next one without knitting, while the thread should be in front of the removed loop, and leave the broach inside the work.The loops can be knitted purl andfacial ones, and therefore the elastic band itself will look different. The illustration below shows a classic double rib knitted with knit stitches.In order to form even and neatthe side edges of the elastic, each row must be finished with the loop that you knit in this row, but it will still be purl. The first stitch of each row must be removed without knitting. This means that one row of this type of elastic is obtained from two passes – First we knit the front wall, and then – rear Depending on the purpose of the double elastic band, the set of loops and the method of closing them may differ.In case you start with a double rubber bandknitting, you should perform the Italian set with additional thread. It is preferable to knit the initial couple of rows and set using knitting needles one number less. Knitting a double elastic band needs to start from the first row.In knitting, where the Italian cast is used,It is very clearly visible (see illustration 2) which of the loops in the first row need to be knitted, and which ones can be removed without knitting. After a few rows, the additional thread is pulled out. Next comes knitting, which will require extra care from you – You should pay attention to even and odd rows. We knit the first row as standard: knit one, remove one – the thread is in front of the loop. Second row: knit the removed loop with a purl stitch, remove the second one – the thread is located behind the loop (the pulled thread is, as it were, inside during the knitting process). If you want to clearly see the beginning of the rows, you can use a contrasting thread. And this is how the process of knitting a hollow double elastic band occurs in the middle or at the end of the fabric:The illustration shows relateddouble elastic straps and top part. During the transition to knitting elastic bands, two are knitted from each stitch of the main knitting (purl and knit), and the knitting needles are taken one number thinner. When you need to switch back to main knitting after a double rib, you should change the knitting needles to a larger size and halve the number of loops – The loop from the front wall is knitted together with the near loop of the back wall. Now we’ll tell you how the loops in a double hollow elastic band are closed. The most successful option here – connect the loops with a needle, similar to horizontal stitching of two fabrics (which is also called a horizontal knitted seam). This is done on the front part of the elastic wall: This is how the back wall is done:The end result is very elastic edges.However, in some cases a hard edge is required. To do this, we finish the elastic in the standard way, but at the same time we close two loops in 1 pass: one from the front of the wall, the other from the back of the elastic wall. You can look at the knitting pattern for which a double elastic band was used:Top – The top part and straps are secured with an elastic band. Jacket – The V-neck and panels are connected using double elastic.

Comments

comments

Comments

Related posts: