Using plastic or as they say, polymer clay, you can recreate a variety of colors and blend absolutely different forms of graphic products.
Clover of polymer clay, a flower of luck for beginners - a master class
Using volumetric clay and beautiful options withadornment of our product, we will try to realize our version of the clover. As you know, clover brings good luck and therefore, this color will always be relevant! You can give it as a gift, so use it as a symbol of good luck in the house. Beautiful clover and materials
- It will take light green polymer clay, dark green polymer clay
- Glass surface
- Knife for polymer clay
To start, you need to create a transitioncolors. To do this, you need to connect both elements and use the rolling pin to make the process of smoothing the materials. Then, it is necessary to roll the sausage so that the glow element is displayed inside. This is due to a change in light green color and a darker shade of it! We form sausages for clover Then, sausageIt is necessary to cut into two pieces, and then - to form a sausage with a shape in the form of a "drop". They must also be cut to pieces to get the main element of the leaf "Clover" - the petal of the clover. Further, using an angle of 90 degrees, wewe make the punching of troughs on each petal. By pressing down on the stele, we make the curvature of the element using our finger as a tool. It turns out the option of "blown hearts". Then, each petal in its middle must be equipped with a hollow, but not using a sharp object for excavation. The clover leaf in our form will be foursheet. Each angle is 90 degrees. For each sheet it is necessary to form the corresponding corner and get the leaf that we need. To do this, you can use the "stack" tool. It turns a variant of hearts. Then, we form the substrates in order to complete the product. For this, it is necessary to lay the leaves gradually on each edge, starting from the hook. Then, we get a real clover leaf! Finishing the Clover Design Using the outline,we cut out the product and separate the substrate from it. Then, using the middle of each color, put a ball with the color of the petal and with a toothpick, attach it to the petal. With the help of a stack, visually it is necessary to separate the petals from each other. The main thing is, do not cut the backing. The work will come out this way. With the help of a toothpick, it is necessary to formstreaks for each petal. With cautious movements, without tearing pieces of clay. Then, it is necessary to sink the middle with the pigment of the interferential composition. Perllex can be replaced with green shades of mother-of-pearl. We get the shape of leaves and a beautiful product. You can make a lot of these options!