Detailed construction of a pattern of a skirt with an overstated waist.

Detailed construction of a pattern of a skirt with an overstated waist.

The high waisted skirt that will be discussed in this article has the following characteristics:

  • high waist;
  • the presence of a slit and a fastener on the back panel;
  • the presence of buttons on the yoke of the front piece;
  • the presence of reliefs on the front panel.

Remember that everything is easy the first time you try it oncorrect. If you have any doubts, then trying everything on will put everything in its place. You just need to always remember about allowances. The pattern of any high-waisted skirt begins to be built based on the basis of the basic pattern of a classic straight-cut skirt. But before you start building your pattern of a high-waisted skirt, you need to check your base, possibly correct it and make sure that the skirt will fit your figure perfectly.Detailed construction of a pattern of a skirt with an overstated waist .. Picture №1

  • You need to copy the previously prepared drawing of a classic skirt onto a clean sheet of paper with all the existing notches and darts.
  • Next, you need to decide on a comfortable length for the slit on the skirt and the entire garment in general.
  • You need to narrow the bottom of your product along the side cuts by 1.5 cm on both panels.
  • You should raise the waistline by 5 cm, while all side cuts and darts should be mirrored.
  • Considering the features of this model, it is necessarynote that the dart located on the front panel should seem to fall into the relief. To do this, you need to draw a vertical relief line from the top of the dart at the waist to the bottom line.
  • The yoke on this pattern is cut-off and consists of4 pieces (two for the right and left yoke). The length of the future yoke should be determined by the model, and the width is set at 5 cm. Find the TB segment on the front panel. Measure 5 cm from the center of its upper part. Draw a vertical strip and design the bottom of your yoke with a rounded line.
  • Mark the places where the 5 loops will be located.
  • From the picture you can see that the bottom of our front panel is one piece with a fold right down the center.
  • BecauseOur skirt is without a belt, we make facings: one - for two back panels, and two facings need to be made for two side panels of the front panel. The dart located on the back panel needs to be closed. Draw the facing with one piece, not taking into account the allowances, along the entire shape of the upper section of this panel. A similar operation needs to be done with the side part of the front panel, but here the dart does not need to be closed.A detailed construction of a pattern of a skirt with an overstated waist .. Picture number 2

    • Our high-waisted skirt pattern is ready. Its base can also be used to model various skirt styles.

    Comments

    comments

    Related posts:

    Building a pattern and making lovers cats. Building a pattern of shoes for the doll and making them. Building a pattern of house slippers-moccasins. Building a pattern of a dress-sundress with cuts will not be difficult, if you follow the description Pattern of a universal skirt – Every craftswoman will need pencil skirts in her work.