Embroider original tulips with ribbons If you areLooking for an interesting version of handicraft that will give the interior of your home an originality and style, and also fill it with bright colors, then stop choosing embroidery with ribbons. We offer a lesson on the creation of tulips. For him you will need:
- 5 m gabardine;
- 2 m green stripes of satin 6 mm wide;
- 3 m of satin green ribbon with a width of 1.5 cm;
- tape made of satin red, yellow, orange shades 2.5 cm wide;
- embroidery frame or, optionally, a frame made of wood (about the same size);
- Needles with different diameter of ears.
First, we stretch the fabric base on the embroidery frame, and in the absence of the hoop it is necessary to use a photo frame made of wood on which the fabric is fixed with the help of clerical buttons. Embroidery of flowers. Fix a needle in the needle. We begin to pull the ribbon through the fabric on ourselves and form the first petal (from the bottom up). Note that you do not need to tighten the ribbon. Embroider the next petals in the opposite direction - from the top down. So we make a tulip from 2 sheets. In order for the product to be neat from the insidekind, do not do the broach. It is preferable to cut off the ribbons after the completion of each flower formation and immediately cauterize the ribbon edges with the help of a cigarette lighter (soldering the ribbon to the fabric). Similarly, embroider the rest of the tulips. Embroidery of stems. It's time to move on to the stems. For them, we will use a ribbon six millimeters wide green. A needle with a ribbon is displayed on the embroidery from the face. Fold the ribbon in a small tourniquet and extend it near the flower in the fabric. So we got a thin stalk. If necessary, in a number of places, we sew the stem with threads of the appropriate color. The ribbon is cut after each stalk and cauterized, similar to how we do in the process of embroidering flowers. We make embroidery of leaves. To make delicate leaves, you need to take a green ribbon of satin with a width of one and a half centimeters. The needle with ribbon is removed from the front side and embroidered in any order. Ribbons are cut and cauterized. In the end, you should get something like thisItem: Make a picture. If you have a desire to do the painting with your own hand, then you will need a frame and a cardboard of the appropriate size. Draw a picture, perhaps with a conventional photo frame. Glass is not required for it, because it only spoils the appearance, pressing down the ribbons and depriving them of their volume. If you do not want to abandon the glass, you needUse special deep frames or make a passepartout in several layers, which will not allow to press glass on the embroidery. Next, the embroidery is applied to the cardboard (so that the fabric base does not move, it is fastened with clamps, or in the extreme case with clothespins) and the fabric is pulled back by lacing. Make sure that your wrong side is elegant enough and there are not too long "tails" of ribbons that can shine from the back side or stand out with hills. Before attaching the fabric to the cardboard, we recommend checking its general appearance. We put the product in the prepared frame and enjoy our picture!