This model can be composed of a double sheet of an ordinary school notebook. The lesson is ideal for beginners. It is necessary to fold the sheet together. Then, horizontally use two folded in half strips. With one lane you will make a hull for the future tank. Then, it is necessary to straighten the strip and place it horizontally. The right part should be folded alternately in the ug up and down in such a way that diagonal excesses are formed, intersect each other. The corners for the upper layers must be bent in the right vertex. Get the right square. Then, the upper and lower part of its vertex bends to the horizontal. Then, the right corners are refueled in special pockets. Similarly, the left side for the squares of the squares is deformed. The upper and lower parts must be folded so that they touch the horizontal axis. Then, turn the workpiece over. In the right-hand part, we trim the left in such a way that the upper and lower corners are aligned with the vertical axis strip. Then, in the same format, pivots the left side, imposing it on the previous addition. Then, move the overlaid part to the left. Fix the corners a little, the folds of the deformed square are hidden. Then, proceed to the design of the running gear -caterpillars. To do this, turn the workpiece. Bottom and top are strips for the top layer 1 cm wide to the center. In the four corners there will be three-fold folds. Then, again folds the strips to the center so that they coincide with the inflection lines. Next, arm our tank. To do this, we supply it with a tower with a powerful gun. For this, in the remaining strip we make a division into two parts. In one of them we make an overturn in half. Then, add the upper and lower parts in the resulting inflection line. We turn the workpiece. Fold the corners and transform the right side into trehgulnik into two levels. The upper layers of the corners are added to the horizontal strip. Then, transform the left side of the double trehgulnik. Then, in turn, raise the trefoils in the upper layer of the left side, and then fold them to the horizontal upper and lower halves. Then, drive away the perpendicular triangles toback part. The leaf is divided in half, the tube is folded from it. Splash in the upper part perpendicular. Then, install in the slot of the tower. The tank is ready, you can attack your toy enemy!