Coat with a hood looks not only aesthetically pleasing,but also functional. Using the hood, you can reliably protect yourself from the weather and replace it with a hat. But sewing on your own requires more time and effort, but after you create an original model, which can not be overlooked. Modeling a coat with a hood 1. on the pattern of the shelf on the seam on the side of the armhole, measure about 11 cm. Draw a horizontal line, to cut off the top element of the product from the bottom. Tuck the chest on your side (see the picture). With the help of a pattern draw a new feature of the armhole. Extra pieces of material on the armhole, which turned out as a result of modeling, folded into folds. If you do not want a wrinkle on the armhole, then you can keep a horizontal tuck. Lower the transfer cut along the marked contours and expand into folds. On the side seam of the shelf, it is necessary to unearth (see the figure). 2. on the back half do the same, that is, cut up about 11 cm from the armhole. Tuck off the cleaning. The bottom of the pattern is done differently. On the central line of the back, add 8 cm to the counter fold. Along the side seam. The lower element of the pattern is cut with a fold of material along the central line of the back. 3. The cuff pattern is cut with a fold and padded with non-woven fabric. Note that the cuffs have small folds located on the front of the sleeve. 4. In addition, the bags of pockets and the gate are cut. As a result, it is necessary to cut out the main material: • two upper elements of the front part • two lower elements of the front part • two elements of the bottom • one upper element of the rear part with folding • one lower element of the rear part with folding • two elements of the sleeve; • two elements of the sleeve cuff • two elements of the folded pocket sheet • two folding gate elements • two hood elements • one hood hood element. From the fabric for the lining turns out:• two elements of the front half, not including the bottom • one element of the back half with a fold • two elements of the sleeve • four elements of the pouch pocket • two hood elements without taking into account the obtachku.Elementy front and back of the fabric for the lining are completely cut. On the elements of the fabric for the lining are not performed folds, only flared on the sides. The sewing processWith folding the folds at the bottom of the shelf. The upper elements are transferred to the bottom and sewed on a typewriter. Make slotted pockets with a sheet of overlay. On the bottom element of the back half fold the opposing wrinkle. To nazhivlit and sew the upper and lower elements of the back. Make seams on the sides of the product. The cuffs of sleeves are laid with non-woven fabric and folded together. Spoon and sew the cuffs along the bottom edge of the sleeves. Sleeve the product to collect on the pellet, nazhivlit and sew in the armhole. From the inside of the gate to lay with non-woven fabric, sweep along the outer cut, sew, turn and clean the edge cleanly. Stitch. The gate is sewn into the armhole, from the top to the front side of each side put a short, nazhivulit and stitched. Unscrew the bottom of the face, iron and stitch it. Sew the lining of the product. Layer the lining along the dash line and the neck of the back, not sewing a distance of about 15 cm, sew. Unscrew the lining on the face, pull it into the sleeves, bend it and stitch it with your hands, grabbing two layers of the cuff, connected together. Bottom edge of the base material to gather up to the length of the lower edge of the lining, the product. Through the gap left on the edge of the bottom we pull the bottom edge of the product and the lining, nizhivulit and stitch. The left distance to sew by hand an inconspicuous line. On the stitches sew the hinges and buttons. Here our coat with a hood is ready!