Well, what man does not wear trousers? Of course, they are worn by all males. If you decide to sew trousers yourself, then you have got where you need. We have a secret to create a pattern of men's pants, which will be relevant for both men and boys. This pattern is basic and it is intended forpeople wearing 46 and 54 size. For other sizes, you can build a pattern yourself taking into account the measured parameters - waist circumference, hips and trousers length. To sew trousers, we need: Fabric suit, the width of which is 150 cm, length 170 cm (this piece of cloth is designed for 44 size); lining fabric, in width from 140 cm, in length from 70 cm; glued lining; twenty centimeters of lightning; button. We calculate the details and distribute the main facial tissue: on the front part of the trousers we take two parts, on the back part also; For a slope, one part is taken. For the right side of the belt, one piece is cut out, for the left part there is also one part. For the glued lining is taken belt, gulf and obtachki. For the lining part: four parts for the front pocket; for the back pocket there are two parts; Lining for the front half is needed here. For bending and processing the edges, we calculate: to process the bottom, we need four centimeters of fabric, and along the other edges of the cut fabric, about one and a half centimeters. The process of sewing trouserscut, you need to lay out a pattern over the fabric, which is folded in half, the front face to the inside. The edges are surrounded by chalk or a special pencil. Then apply the glue lining to the belt line, obtachkov, gulf, slopes and pockets. On the backs, it is important to grind the grooves and press them to the center. On the front parts of the canvas we lay the folds, while directing them to the center, and then perform their marking on the upper cut. We process the slotted pockets on the backparts: to the back side of the product, you need to iron the backing strip from the back part, equal to 4 cm above the marking. We work with pockets, iron their obtachku, pin, process edges and seams. All pads and burlap are correctly labeled on the wrong side. To the front of the trousers we take the upper obtachka. We work with a lining, apply it from the back of the product and sweep it. Correctly sew a zipper. On the underside of the pants also from the wrong side we sew the obtacks, we sweep the hem and round the folds. The last stage will be work with a part of the belt, sewing patterns, already folded twice and with turned edges. To do this, the central portion of the facial suture is ground, then we process the back central seam to the upper part of the belt. The original cuts are turned and stuck into the prying area. So, we have got wonderful classic men's pants!