To make a three-dimensional snowflake in origami technique, we offer you detailed schemes
A three-dimensional snowflake, made in origami technique,will be a wonderful decoration of a window or a room in the winter season, especially on New Year's holidays. It will take a little more time to complete than a simple snowflake, but the result of the product made by oneself will please with its aesthetics. Origami - an ancient art form, which invariably attracts the attention of residents of different countries. Different figures of paper differ in their originality. The origami technique assumed the use of only a square sheet of paper, but over time, it was improved and some of its types can be used in the creation of products, scissors, glue, and paper clips. The result exceeds all expectations. In the technique of origami, you can perform any figure of a bird, animal, object. Today we will try to understand how a three-dimensional snowflake made in origami technique is being made by own hands. This is not so much a simple process of work, as in the case of a simple simple snowflake, and it will take much more time. If you make a snowflake for the first time, then prepare yourself, which you need, approximately, about an hour of time. The subsequent products will be performed much easier and faster. As a result, you will be able to please yourself with the beautiful gentle symbol of winter. Important! The thinner you choose the paper, the more delicate and elegant the finished product will be. The first stage of the work will be the transformation of a paper sheet, rectangular or square, into a regular hexagon. On this depends on how successful the handicraft will be. To begin with, you need to fold the paper two times twice so that the folds are clearly visible. Then one of the corners is bent to the central part and the valve from above is bent downwards, as in the photo. Once again, bend the paper in half, and then in the same way as in the picture. Bend the valve, according to the figure below, so that in the end we get a figure resembling a heart. Part of our figure, marked in blue, is cut off, since we only need a hexagonal shape to make a snowflake. One side of the hexagon must be bent tocenter - you will get one more fold line. The same actions are done with the rest of its sides. As a result, small triangles are formed. According to the previous folds in the direction to the center, bend all the edges of the hexagon. As a result, you get a figure that looks like a turntable in appearance. The valve formed by the last one will turn out to be hidden, so it must be pulled out so that all the valves stick outward. It is not necessary to press a finger on each of the pockets, its fold. On each of the pockets, it is necessary to bend the two corners, so that the fold lines are obtained for further work. Next, perform the manipulations as shown in the picture. We turn our workpiece and every cornerbend to the central part. A small valve forms each fold. The valve under the fold does not need to be hidden. Do not strongly press the fold lines of all valves. All the folds that were made in the previous stage, we turn out, the valves, while hiding. Turn the part and turn each of the corners away. As a result, we have twelve valves, six of which are large and six are smaller. We turn the product over again and push all the small valves forward. It turns out rhombs, six pieces. Further actions are carried out as shown in the photo. A beautiful three-dimensional snowflake made in origami technique is ready.