
Master class on knitting hats with a bow for a girl, a detailed lesson with a photo and description
Dress up girls like all moms. Ruchechki, bows are favorite decorations of little princesses. Here's a cute hat with bows will help you tie this master class. To knit a thin spring cap we will need a yarn "Pechora" Acrylic "300 m / 100 gr. Hook 2.5 mm. Abbreviations:
- VP - air loop;
- SSN - a column with a crochet;
- SBN - a column without a crochet;
- SP - connecting loop.
First, we consider the diameter of the bottom of the capneeded. We measure the head of the child from the back of the head to the forehead. Further we assume by the formula: x: 3,14-2. In this case we knit on the head circumference 44 cm. The size of the bottom is 12 cm. We dial 12 CLS on the magic loop and knit according to the scheme to the desired diameter. If you do not get the bottom of the desired diameter of the CLS, you can tie one row of RLS. Decoding of the scheme:
- 2 rows: 2 CCNs to each loop-base;
- 3 series: * 1 CER + 2 CCH in one loop-base * repeat to the end of the row;
- 4 series: * 2 CER + 2 CCH in one loop-base * repeat;
- 5th row: * 3 CCN + 2 CCN in one loop-base * repeat;
etc. In each row, the number of CCN increases before adding to 1. We continue to knit without a raise. We measure the depth of the cap, from the crown to the middle of the forehead (where the cap will end). Take away 1 cm, leaving it under the harness. In this case, the depth of the cap will be 15 cm, without strapping 14 cm. We will knit with the following pattern.
Decoding the scheme: We dial 3 VP, we are tying it into the same loop-base of 3 CLS.
We pass 4 loops, in the fifth weave the RLS.
Repeat the picture to the end of the row. We close a number of joint ventures. We send 3 SP to the top of the corner.
We unfold knitting. We collect 3 VP and we knit 3 SSN in the middle of the chain of the previous row.
We send the RLS to the top of the next corner.
We repeat to the end of the series. Thus we knit to the desired depth of the cap (in this case 14 cm).
When the cap of the required depth is connected (in this case, 12 patterns were obtained with a pattern), we begin to make the strapping with a shell pattern. We start to knit from the top of the corner.
We knit the SSN into the lower loop of the corner.
We make 5 SSNs in one loop and we tie the RLS to the top of the corner.
Thus we sew 2 rows.
We make bows to decorate our hats. We dial 40 VP and close in a circle.
We knit 3 rows of CLS.
We dial 12 VP and we knit 2 rows of RLS.
We pull a large detail in the middle of a small detail, we make a bow. Leave the thread to bind.
We make the second bow. We sew the bows to the hat.
A cap with bows is ready! You can go for a walk! Buy a baby hat with a bow can be at our Fair!