The most popular direction of needlework isknitting with various hats. Probably, this is exactly because these products are fairly simple to perform, do not require a lot of time and, at the same time, are very comfortable, practical, feminine, beautiful and give a special charm to any woman. In most cases, knitting patterns of hats with knitting needles are quite simple, although there are hats made with a rather complex pattern. Nevertheless, if you want to find something special and interesting, it will not be difficult. To tie a beautiful, comfortable and original hatwith their own hands, perhaps in a few evenings. For this model, we need 2 rolls of 75 m thread, circular knitting needles No. 4 and No. 5, auxiliary knitting needles and two beautiful buttons in the tone of the product. The length of the cap in a circle is 54 - 58 cm. The first 4 cm of our caps are knitted in rows. We type on the spokes No. 4 86 -94 loops, depending on what size we expect to receive, and knit the first row of rubber bands with the wrong loops. In the second row, the 6 first loops knit with garter stitch, then the facial loops alternate with the purlins (2x2). We finish the series, tying 6 loops garter stitch. Having connected the desired height (4 cm), we pass to the circular knitting needles No. 5. Then we knit the cap in a circle. In the first row 6 loops are knotted with garter stitch, then 1 face loop is alternated with 1 purl (1x1). The last loop is the back one. The second row we also knit 1x1, and we take off the loop, without tying it, by knitting the wrong side, and finish with the 6th loop of garter stitch. In the third row, we knit all the loops, and the last 6 - with garter stitch. The fourth row - all the loops are purl, 6 of the final - with garter stitch. Thus, we continue to 8 cm and close the first 6 loops, with 80-88 loops remaining. We continue to knit as follows: The first row is 1x1 (the front one is purl), while the last one is the wrong one. Next, the second row begins with the removal of the loop, without tying it, and continue to the end of the row 1x1, starting with the wrong loop. The third row is knitted with facial loops, the fourth row is sewn with the backs. After 20 cm of the cloth, we pass on to the garter stitch, cutting 12 loops in each third row. Abbreviations need to be done 5 times. As a result, there are 20 - 28 loops left on the spokes. We impose them on two together, we cut the thread and stretch it into loops, pulling them together. Sew two layers together. The hat is ready. It remains to decorate it, sewing 2 decorative buttons on the side.