Today's master class is dedicated to weaving palmsfrom beads. Probably everyone at the lessons of work in the school had at least one lesson devoted to weaving from beads. I had such a lesson, but, unfortunately, we were taught only the basics. And after many years, I decided to go back to that lesson and learn how to weave different interesting crafts with my own hands, and it turned out to be not so difficult! PALM FROM BISERA (banana tree): We will need: - beads number 10: green, yellow, brown (I used brown balls of a larger size, but I recommend using only one size for all colors); - Wire 0.3 mm Diameter. First, we need to make the leaves of the banana tree in the technique of parallel weaving. For each sheet, take the wire 70 cm in length and use only green balls. These leaves will be of three different sizes. For small leaves we adhere to the following scheme: 1st row: 1 bead; 2nd row: 2 beads; 3rd row: 3 beads; 4th row: 4 beads; 5th row: 5 beads; 6th row: 4 beads; 7th row: 3 beads; 8th row: 2 beads; 9th row: 1 bead.We have to make 4 such little leaves. For medium leaves, we adhere to the following scheme: There will be 20 rows in total. Starting on the front row with a bead, 2 nd - 2 beads, the third - 2 beads ... we add in every second row on one bead, and so on until the tenth row. In the tenth row we will have 6 beads. In the eleventh row as do 6 beads, and then go on the wane in the same way (in a row at 1 bead less). We must make 4 such medium sheets. For large leaves adhere to the same pattern as the middle leaves, only in large leaves we will have 24 rows. Thus, we will get the maximum of 7 beads in 12 and 13 rows. We will have 5 such large sheets. Now we make a branch of bananas from yellow beads. Take two pieces of wire each 30 cm long. We will pass both pieces through one yellow bead. Put it in the middle. Take 40 beads and put 10 beads on each end of the wire. Take one more yellow bead and thread through it 4 ends of the wire, tighten it tight. We got a bunch of bananas. You can make as many such banana ligaments as you want. I made 3 and twisted them together. Let's collect a banana tree. To increase the strength of the barrel, we make another piece of wire 50 cm in length, bend in the middle and connect with a large sheet. We put together all the large leaves. Then take the middle leaves and attach them one by one to the trunk just below the previous series of leaves. A little lower attach to the trunk small leaves. After this, fix the bundle of bananas to the tree. Then we need to decorate the trunk with brownbeads. Take a long wire and fasten it on a tree near the bananas. Put a lot of brown beads on the wire and wrap it around the trunk from top to bottom, adding more beads as needed. In the lower part of the barrel, carefully cut off excess pieces of wire.The banana tree is ready! Put it in a suitable stand and straighten the leaves. See also the diagrams of how to make decorations from beads and flowers from beads with your own hands.