This master class will teach you how to make an unusual keychain for your hands - an iron birdhouse

December 10, 2017 handmadebase

In fact - no one claimed that the hand-made- the passion is extremely soft and feminine. No! Many types of needlework, such as macrame, for example, are borrowed from men. So a diverse world of creativity can conquer a man of any gender and age, regardless of the materials used. Our birdhouse attracts with its extraordinary beauty, adorning the keys, in the car, on the tree and in the interior decor. And its strength, power and beauty can only be envied. It can even be used for self-defense. So, to create it you need:

Bulgarian with grinding and threaded discs for metal;
Drill with two small drills, nozzle with an emery wheel;
Pliers, vice, working convenient table, punch, marker for markings, ruler;
Welding machine, one electrode number 3;
Nails small - 2 pieces;
The 15-inch black tube is about five centimeters long;
A piece of sheet iron with an area of less than 10 square centimeters;
Paint aerosol silver;
Nippers.

Course of work: The main parts of the craft are a pipe and a piece of iron. And the first step is to prepare the basis forwork. The main goal of the stage is to make a piece of pipe with a bevel at the top. First cut off the tube length of 3.5 cm. We mark the mark of the bevel - 5 mm below, cut off by the Bulgarian. From one edge 3.5 cm, from the other -3 cm. Then we clean the workpiece from rust and paint, using a grinding wheel on the tool. Now we are preparing the roof for the birdhouse. A piece of iron must be previously sanded with a drill with an emery nozzle on both sides, holding it in a vice. The roof will be rectangular. Its width coincides with the diameter of the pipe according to the fitting, the length is slightly larger. The dimensions are 2.2 cm by 3 cm. Now you need to try on the bottom, circling the markercircumference of the upper part of the birdhouse along the perimeter. Cut off the circled detail, again try on and grind the edges of the detail with the Bulgarian. Weld by welding the bottom: first make the connections inside, then outside. The bottom was welded first, then the roof. Next, the marker marks the entrance for the bird and the stand for it. Then you need to punch the punch with the punchhole for the entrance of the bird and drill it with a suitable drill bit. Under the hole made, similarly, do the same, using a smaller bit. As a result, the necessary holes are ready. We prepare the poultry stand as follows: a thin small nail of the size under the hole is sharpened with the help of a grinder and a grinding disk We insert the nail into the lower hole. Leaving about 3-4 mm from the bird's wall, remove the excess with the help of nippers and see the result. Remains quite a bit: from a piece of iron cut off a stick with a width of half a centimeter and try it on a birdhouse. Weld the part to the product. The semi-finished product can be cooled in water for finishing strokes. Firstly, we must grind the hobby of the Bulgarian. Secondly, in a roof to drill a hole, carnations to bend into a loop, to cut off an extra edge of a nail. Third, weld the prepared fixture. And that's all! It remains only to paint the resulting birdhouse with an aerosol can with silver or any other paint. So he looks in the workshop, if you attach a chain with a ring to the loop. And so it will look like a keychain or in the form of Christmas decorations.

Comments

comments

Comments

Related posts: