Scarf - this is an article, when knittedyou can give full freedom to your imagination. Nobody forbids you to use any patterns. At the same time, there is no need to resort to patterns. Even if you just started to master the knitting technique, then no problem, you can cope with the knitting of the scarf. And to complete the stylish image, tie a set - mittens and a scarf! The process of knitting a scarf does not take much time. The only thing that is required of you is to choose a pattern you like and, on its basis, to make a strip of any length and width. It is best to do this by crocheting, since the spokes do not allow you to achieve the ideal beauty of the finished product. This is due to the symmetry of the patterns located on both sides of the scarf. In order to make your work as simple as possible, you can use, as a variant of knitting, a knitted type of mesh. It is very convenient for making a scarf, since all the loops are facial. This scarf looks great in a two-color range. The main thing, only, do not forget to repeat the colors not earlier than through 2 rows. Pretty popular variant of knitting a scarfis English gum. If desired, you can connect fantasy and creativity. Try combining: knitting of a handkerchief type connect with an English rubber band - it will look unusual and original! In a set for a scarf, we suggest to tie warm, beautiful mittens. This is something everyone can do. The only thing you have to learn is the method of circular knitting. But, because you are not afraid of difficulties, is not it? Then let's get started! Method 4 spokes. When making mittens by circular dialingUse a four-fold set of loops, and accordingly, 4 spokes. If each of the spokes allocate 11 loops, you will get a kind of circle. Row the rows better from the spoke at the end. When binding, edge loops are not used. The length of the mittens is determined by the height of the gum. After determining the desired length, you can begin to bind the mittens with eyelets of the facial type using the so-called "hosiery" method. Increase the number of loops, thus, it is not necessary, since the shape of the mitten is formed due to the change of the mating. The thumb is sealed separately. At the place where it is necessary, using another spoke, dial 8 loops from the tied row. Replenishment of missing loops occurs by the method of their dialing on the working spoke. The thumb is circled around the circle. At the end of mating the mittens of the eyelet should be reduced. Method 2 spokes. When using 2 spokes, the back sideis executed to the tip of the little finger, and then the eyelets are removed. The inner side is tied in the same way, except that, closer to the base of the thumb, the loops need to be disconnected into 4 parts. The parts are distributed as follows: 3 parts are retracted to the extra spoke, and one more to the working one. After these manipulations, you need to dial the same number of loops on the 2 spokes as fixed on the main spoke. To do this operation, you need an additional thread. The thread should be bright color - so you better see it among the rest. At the end of the work, the thread is removed. The new loops are made with a thread of the main tangle. At the end of the work you should get a cut out thumb. An open-type hairpin is attached to the pin away from the finger that you are tying, and the additional thread is finally removed. The loosened loops along with the eyelets with which the finger was performed are fixed to the spoke. The finger is ready. At the end of knitting, you need to loosen the loops at the top and fix them with a thread. The base of the thumb is sewn with a knitted suture. Mitten is ready!