Means for decoupage allow everyone to createthe most unique, extraordinary and exciting things. It's time for two people to marry - this is a special period and a gift in the style of decorating decoupage is perhaps the best choice in order to leave the newlyweds with a great memory of this day. In order to make a gift, do not go far. We are sure that almost any newlyweds will not refuse to recruit new, beautiful and unique wedding glasses. This you can do. How?
Wedding decoupage glass and a master class with photos for recruitment
To begin with, you need to wash the glass with which youwill work. We wash it with a detergent, and then get rid of fat with alcohol. It is necessary to treat the outer surface of the glass. Then, you need to take a paint tape and cover the surface of the glass glass. This must be done in order to later drink from the glass, and the lips do not touch the materials. Glass processing: cleaning and priming After this, the cup of the glass in the lower part of the tape should be wrapped with rice paper so that the edge of the paper is overlapped by 3 millimeters. We remove excess paper by means of scissors or a knife, or break it off. Next, we glue the rice paper to the glass using ordinary water. Water should be distributed evenly, using the entire surface of the paper on the glass, for this we need a brush. Apply the flower motif for a glass in the mosta good place. Next, we apply glue for decoupage using a brush, using the surface of the whole figure. We move through small strokes using the center and edge of the product. The product must dry. Glueing Images We have already soaked the rice paper, now it has elastic qualities, therefore folds of paper can be cut off. Next, we apply glue for decoupage using a flat brush, directly onto the paper. We leave our product to dry. We cut out the necessary motif of the flower, remove the multi-layer napkin from the white layers, leaving only one layer of the colored type. Flowers are laid out on a film or a file of plastic. Then, spray with varnish for three times, using an intermediate drying. Thus, our drawing will be laminated, which means it will be easier to stick to where we need it. Decorating a glass for a wedding We apply vitreous varnish on the areazadekorirovannoy surface varnish, leave the product to dry. The leg of the glass, which is the bottom, we leave clean. The other part of the leg is covered with a paste of crystal. This pasta of decorative type consists of glass beads and, therefore, it is easily processed with a palette knife. When the varnish and paste dry, you can remove the scotch. We expect imitation of the pearl with the help of special paint, on the leg of the glass and around the edges of rice paper on our product. We paste several times, if desired. The product is ready! You can make a whole set of these glasses!