Lesson on knitting of socks with a seam by two spokes onIn this article we suggest you learn how to tie socks with a seam with two spokes according to the scheme. After the process of knitting is completed, the socks should be sewn. In this case, the seam will be located on the upper side of the sock. Before you start knitting yourself, you need to calculate the correct number of loops correctly, focusing on the leg circumference. In our work we knit forty-eight loops and two more edge loops (total, fifty loops) on two spokes. Next, create a straight canvas of five to six centimeters, using a pattern of "rubber band". After that, we go to work with a facial smoothie or with any other pattern you like (seven to eight centimeters). Proceed to knitting the heel: the total number of loops, not considering the edge, must be divided into four equal parts. There are twelve loops each. Manufacturing of the heel will take place in 2 parts in the middle. We knit the eyelets in three parts for twelve loops. After this, we rotate the work and then create twelve plus twelve loops (2 parts in the middle). Then again do the turn of the canvas and create twelve plus eleven loops. After again do the turn of the canvas and create eleven plus eleven loops. Thus, in all rows we create one loop less (we get shortened rows). So do until there are eightloops. And already from this moment it is necessary to begin to increase the number of loops, which in work, in all rows, knit a loop that was previously removed. In order to avoid cracks in the canvas, you need to do this: on the left spoke, pass the side loop and tie it together with the subsequent one. As a result, the total number of loops will increase by one. Then you need to repeat the turn of the canvas, take off the first loop, tie eight back loops, make a side loop on the left knitting needle and knit together two purl loops. So do until the other loops are working (twelve plus twelve). The knitting fabric looks like this: Further knitting is done using the basicWe create a straight canvas on all forty-eight basic and two edge tabs. The length is determined approximately to the center of the big toe. After that, go to knitting the toe. Again, you need to divide the loops into four equal parts: four times twelve loops. Decrease is carried out in this way: in all the second rows, the third and second loops from the final part of the first and third sides are knitted together by facial loops. But the second and third loops of the 2 nd and 4 th sides are knitted together by broaching. After you have fifty percent of the spokes on knitting needles, you need to start making similar cuts in all rows. Do this until the spokes have six working loops. These loops need to be tightened with a thread. It also needs to connect the parts of the sock. As a result, the seam will be located at the top of the product.